Dual-signal wires version, signal break-point continuous transmission. If one pixel is damaged, it will not affect the other LEDs working.
Light source: 5050 RGB LED
Led Qty: 60pcs per meter
Wave length (NM): R,650nm ; G,520nm ; B,460nm
The gray level: 256
Color: full color (24-bit )
Voltage: DC 5V
Waterproof: waterproof IP67
FPCB board color: white
5V: Power Voltage, connect to "+5V"
DO: Control data signal output
DI: Control data signal input
BO: Backup control data signal output
BI: Backup control data signal input
GND: Data &Power Grounding
1) The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel.
2) The control circuit and the LED share the only power source.
3) Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place.
4) Built-in power-on reset and brown-out reset circuits.
5) Port scanning frequency reaches to 2KHz/s.
6) Serial cascade interface. Data receiving and decoding depend on just one signal line.
7) Dual-signal wires version, signal break-point continuous transmission.
8) If the transmission distance between any two points is less than 3m, another circuit is not needed.
9) When the refresh rate is 30fps, cascade numbers are far more than 1024 points.
10) Data transmitting speed is up to 800Kbps.
1x 16.4ft 300 pixels WS2813 led strip
5x silicone clips
You may need these to make the LED strip work
5V 15A Power Supply:
WS2813 LED Controller: